Heater Focusing Reflector, Outdoor Heat Reflector Shield for Natural Gas Heaters and Propane Patio Heater, Directional Heat Reflector Protective Shield 1 Pcs
Buy Now, Pay Later
- – 4-month term
- – No impact on credit to apply
- – Instant approval decision
- – Secure and straightforward checkout
Ready to go? Add this product to your cart and select a plan during checkout.
Payment plans are offered through our trusted finance partners Klarna, Affirm, Afterpay, Zip, Apple Pay, and Google Pay. No-credit-needed leasing options through Acima may also be available at checkout.
Learn more about financing & leasing here.
Selected Option
Non-returnable. Transportation of this item is subject to hazardous materials regulation
View our full returns policy here.
Recently Viewed
Size: 1 Pcs
Description
The highly reflective, aluminum surface bounces heat like rays of light, similar to how a flashlight uses a reflector to focus light in the direction you point it. The durable construction of our reflector means you get quality you can count on for the life of your heater. Heat Focusing Reflector for Round Natural Gas and Propane Patio Heaters.The directional heat reflector, the protective cover of the outdoor terrace heater reflector, will be the most effective for heating a specific area. Our heat focusing reflector redirects heat where you want it, protects trees and walls from unwanted exposure, and saves on propane. Enjoy the perfect amount of warmth, while using the minimum amount energy STEP 1 Make sure the gap is large enough to fit the rim of the overhead reflector on your heater. IMPORTANT: Prior to installation remove all packing material and peel film from the front side of the reflector. Do not remove the soft protective screw cap or the soft rectangular protective sleeve from the clamps. Those clamp protectors are made from high heat resistant materials. They are intended to stay on during use to increase clamp grip and help prevent scratches during installation. STEP 2 Make sure the heater is cool and shut off or disconnect the gas source prior to installation. Locate the gas control knob on your patio heater. As shown in the diagram, position the middle clamp of your Heat reflector on the opposite side or approximately 180 degrees from the location of the gas control knob. Place the rim of the heater's overhead reflector into the middle clamp. Tighten the middle thumb screw until it is snug. Overtightening is not necessary and doing so may dent your heater. Verify that the middle clamp of your Heat reflector is installed on the opposite side of the gas control knob as shown or adjust the location as needed. Failure to follow these instructions can result in heater damage and personal injury. STEP 3 Gently bend either side of your Heat toward the heater until the rim of the patio heater enters the clamp on that side, then proceed by tightening the thumb screw until snug. Repeat the same thing for the other side and you're all done! Check the thumb screws often to make sure they have not loosened up and are still tightly fastened to the heater top. To remove your Heat just follow these same steps backwards. Loosen the side clamps first and then remove your Heat after untightening the middle clamp. Just remember, never handle your Heat while it's hot. Touching your Heat while hot can result in personal injury. STEP 4 Always make sure all three clamps are fastened securely before turning on your patio heater. When ready to use, safely connect the gas and ignite your heater. Keep in mind that your heater will now deliver much more heat than it did before. Proceed with caution and do not stand or sit too close until you know how it performs. It may be best to start off with low heat at first to make sure you do not overdo it. Slowly increase the heat until you're comfortable. Please remember to remove your Heat when not in use and do not have it installed in windy conditions above 5 miles per hour. If a heater is not properly secured there is a heightened risk of tipping. Check Clamp Parts Connect Middle Clamp Fasten Side Clamps Installation Completed Height: 15 inches Width: 35 inches Weight: 2 lbs Materials: Aluminum Built to Last Every Heat Reflector is made with high grade aluminum and machined with precision. With functional design leading way, is an absolute upgrade for your patio heater.
Brand: MOARON
Special Feature: Directional Heat Reflection, Portable, Weatherproof
Color: Black, Silver
Form Factor: Dish
Indoor/Outdoor Usage: Outdoor
Special Features: Directional Heat Reflection, Portable, Weatherproof
Form Factor: Dish
Indoor Outdoor Usage: Outdoor
Power Source: Gas Powered
Heating Method: Radiant
Recommended Uses For Product: Outdoor
Mounting Type: Floor Mount
Room Type: Living Room, Patio
Heating Element: Radiant
Fuel Type: Propane
Brand Name: MOARON
UPC: 888957182730
Item Weight: 2 pounds
Color: Black, Silver
Frequently asked questions
Non-returnable. Transportation of this item is subject to hazardous materials regulation
View our full returns policy here.
- Klarna Financing
- Affirm Pay in 4
- Affirm Financing
- Afterpay Financing
- Zip Pay in 4
- Financing through Apple Pay
- Financing through Google Pay
Learn more about financing & leasing here.
Top Amazon Reviews